816-229-0804

Home/Other Tools/One Inch Capacity C-Clamp

One Inch Capacity C-Clamp

CODE:

C5-12

Write a review

$3⁷⁵

+ −

Ask a question

Small blue one-inch capacity C-clamp with metallic screw.

Description
Related Products
Reviews

Small C-Clamp for installing the lower rails in your receiver or for clamping the scribe jig to the bent receiver to mark the cutouts of the top rail.

Angled view of AK-Builder steel Rail Alignment Fixture showing front clamp and screw.

AK-Builder Rail Alignment Fixture

0.0

CODE:

C3-61

AK-Builder rail alignment fixture — positions and clamps lower bolt guide rails in stamped receivers for accurate welding and alignment.

$29⁹⁵

In Stock

Quantity:

+ −

Angled view of two uncoated high-speed steel 5mm and 7mm reamers for AK receiver pins.

5mm & 7mm Reamer Set

0.0

CODE:

A2-31

5 mm and 7 mm reamer set for finishing AK hammer and trigger pin holes. Use slow speed with cutting oil.

$44⁹⁵

In Stock

Quantity:

+ −

Two Inch Capacity C-Clamp

0.0

CODE:

C5-13

Two inch C-Clamp for clamping trunnions for test fitting parts to your rifle before final installation.

$4⁹⁵

In Stock

Quantity:

+ −

AK Trunnion Rivet Hole Drilling Fixture

0.0

CODE:

T3-11

Here is a professional tool for drilling the front and rear trunnion holes in AK47 receivers. This tool will work with 7.62 and 5.45 trunnions using two different expanding mandrels that fit into the trunnion. The red mandrel fits the 7.62 and the blue fits the 5.45. The...

$99⁹⁵

In Stock

Quantity:

+ −

Add to Cart

AK-Builder Bulgarian-style center support sleeve and rivet for 1mm receivers, heat treated alloy steel.

AK Center Support for 1mm Receivers

0.0

CODE:

A1-31

AK-Builder Center Support & Rivet — Bulgarian-Style (No Flat) Modern, builder-proven center support set patterned after Bulgarian receivers. The sleeve is round (no flat) by design for correct mag-well clearance, machined from alloy steel and heat treated for strength and...

$7⁰⁰

In Stock

Quantity:

+ −

Spot Welder Tong

0.0

CODE:

A1-41

This spot welder tong is designed to work with the Harbor Freight #45689 welder or 61205-61206 if you get the extended tip . Avoid the 220v welder if at all possible due to the possibility of burn through while welding. The tong will come with a screw-on tip that can be replaced...

$45⁹⁵

In Stock

Quantity:

+ −

No reviews found